STANDARD PROJECTION SCREEN FINISHES

WE SPECIALIZE IN CUSTOM MADE PROJECTION SCREENS TO VIRTUALLY ANY SIZE AND SHAPE.

MANUFACTURING STANDARDS & GUIDELINES

Model 0 Vertically welded panels, no edge finishing.

Model 1 2 1/2" wide PVC webbing with grommets spaced 12" on center on the top (other grommet spacing available). 4" or 6" pocket on the bottom.

Model 2 2 1/2" wide PVC web- bing with grommets spaced 12" on center on the top and sides (other grommet spacing available). 4" or 6" pocket on the bottom.

Model 3 2 1/2" wide PVC webbing with grommets spaced 12" on center on all 4 sides (other grommet spacing available).

Model 4 2 1/2" wide PVC webbing with snaps spaced 8" on center on all sides (other snap spacing available).

Skirt Finish as model 1 or 2 with skirt on front side of screen at bottom edge. Skirt length usually 2" longer than pocket.

Front Side High-frequency welded velcro (hook & loop) is available, please call for details and pricing.

▸ Dimensions refer to the relaxed, un-tensioned state of the projection screen surface.

▸ Normal Seam Direction is Vertical. In the case of Horizontal Seams, customer assumes all risk. We do not guarantee Horizontal seams as there is adverse stress due to excess weight from the overall size of the screen.

▸ Unless otherwise specified at time of order, all high- frequency welded finished projection screens are folded and packed in a box for transport.

▸ To receive projection screens as wrinkle-free as possible, projection screens must be rolled and shipped on a tube (rolling is an extra charge and must be stipulated by the customer at time of order. Practical limitations on size must be discussed.

▸ In freezing conditions, projection screens must warm up to room temperature before removing from box or unwrapping from storage container.

▸ Our projection screens are intended for interior use only with the exception of Arena 86, which can be used outdoors.

▸ Our projection screens are not recommended for use with any other motorized roller mechanisms other than a Gerriets roller mechanism.

A few facts about PVC projection screens:

Most Gerriets projection screens are made of PVC (polyvinyl

chloride), an amorphous thermoplastic that is white, hard and

brittle until it is treated with plasticizers and stabilizers that

make it a malleable material useable for technical applications.

Additional additives make the material flame retardant.

The physical properties of PVC change with temperature,

which means that PVC projection screens become more supple

under heat and harden when they become cold. It is extremely

important that our PVC projection screens are handled and

installed at ambient room temperature, otherwise irreversible

damage to the screen can occur in the form of tiny cracks in

the material.

Many amorphous plastics, including PVC, form small white

lines when stretched, folded, or otherwise stressed. This

result is called Crazing and creates tiny flaws that normally

are not seen under normal projection conditions. However,

depending upon the severity of the damage, these tiny flaws

can turn into visible cracks in the projection screen.

Gerriets' in-house screen manufacturing facility

2928 Projection Screensgerriets.us | 800-369-3695 | info@gerriets.us