An error occured when trying to show the publication. Please check if JavaScript is enabled or try to update your browser.
SPECIFIC SUPPORT POSTS
SPECIFIC ATTACHMENTS
TYPE OF SUPPORT POST USE CHARACTERISTICS
Wall-mounted support
posts and stands with
plates
Range of cantilevers and wall support posts for
mounting police signs in dif f icult locations
350, 500 or 800 mm of fset
Support posts with sleeve
plates
Allows signage to be installed where the ground cannot
be dug out (e.g. concrete f loor)
80 × 40, 80 × 80, 100 × 100 or
Ø60 mm cross-sections
Foldaway hinge support
posts
Allows a panel to be rotated 90° forwards and
backwards, and retracted in the event of impact
Foldaway stainless steel hinge
for securing to a TR/TC vertical
support post or wall**
Support posts for concrete
and metal double barriers
Allows road signs to be installed on concrete or metal
double barriers
Ø60***, 80 × 40, 80 × 80 or
100 × 100 mm**** cross-sections
**Use a standard 80 × 40 prof ile for the vertical arm, max. length 1.5 m, and 80 × 40 attachments to secure the panel to the arm
***Allows the panel to be adjusted
****Only for concrete barriers
TYPE OF ATTACHMENT USE CHARACTERISTICS
Wall-mounted** attachment Discreet attachment for mounting a panel on a wall Set of 2 wall-mounted attachments***
Lamp-post attachment Attachment for all support post diameters
Pack of 2 complete M8 attachments
with or without strap***
Clamp for all support posts
Clamp suitable for all support post types for event
signs
Cast aluminium module and polyester
shell
Vauban attachment
For attaching police signs to Vauban barriers,
fences and railings
Aluminium and stainless steel screws
Attachment for BN4 barrier
Allows a panel to be attached to a support post
along a BN4 barrier
Set of 3 attachments
(80 × 80 support post)
Attachments for support
post on metal barrier
Allows a panel to be attached to a support post
along a single-sided metal barrier
40 × 27 mm cross-section, 2 f langes /
80 × 40 mm cross-section, 2 f langes /
80 × 80 mm cross-section, 4 f langes
**There should be one attachment for every 0.25 m2 of panel surface, with a minimum of 2 fasteners
***Specify the panel range required to supply the right bolts for the panel
Support posts
with plates
Foldaway hinge
support post
Support post with
plate
Support posts for
concrete or metal
double barriers
Clamp for all support posts
Attachments for
BN4 barrier
Attachments on metal barrier
Attachment for
Vauban barrier
Wallmounted
attachment
Lamppost
attachment
P E R M A N E N T V E R T I C A L S I G N A G E
56
