www.brammer.bizwww.brammer.biz www.brammer.biz

7

Lu b

ric an

ts , O

ils &

G re

as es

Lubricating Systems | Lubricating Equipment

SKF MultiPoint Automatic Lubricator Grease Test Kit Oil Check Monitor

7551

Being a do-it-yourself lubrication system, SKFMultiPoint can be easily installed without the assistance of a costly lubrication service company and requires no special training to use. Once the correct grease dispense rate for your application is calculated using DialSet, SKF s re-lubrication calculation program, SKF MultiPoint will keep up to eight lubrication points simultaneously and automatically lubricated, preventing both over and under- greasing. The transparent cartridge housing allows for easy inspection, while an electronic alarm will warn you when the grease cartridge is empty. Advantages: Do-it-yourself centralised lubrication system Up to 8 feed lines Easy-to-use DialSet included: SKF s re-lubrication calculation program allowing accurate calculation of the correct re-lubrication intervals Long feed lines (maximum up to 5 m/16 ft) Electronic setting and read-out of control parameters Alarm function for blocked feed lines and empty cartridge Machine steering (i.e. lubricator only operates while machine is running) High pressure capability (40 bar / 600 psi) Tested and approved with all SKF greases Uses standard SKF grease cartridges (420 ml) Ready for use, all accessories included

Order Code

C1453693

7601

Lubricant analysis is a vital part of a predictive maintenance strategy. Until recently, however, oils were almost always analysed despite the fact that around 80% of bearings are lubricated with grease. Tribology expertise and years of research have allowed SKF to develop a complete methodology to assess grease condition

Extremely useful in fi eld decision-making processes Allows adjustment of grease relubrication intervals according to real conditions Grease can be evaluated to detect possible unacceptable deviations from batch to batch Allows verifi cation of the suitability of certain greases in specifi c applications Helps in the prevention of damage due to underperforming lubricant greases Provides more information on root cause analysis Requires no special training to perform the tests Requires no harmful chemicals Small sample sizes required. Only 0,5 g of grease is needed to perform all the tests

Order Code

C2557066

7603

The SKF TMEH 1 measures the changes in dielectric constant of an oil sample. By comparing measurements obtained from used and fresh samples of the same oil, the degree of change in the condition of the oil is established.

Dielectric change is directly related to the oil s degradation and contamination level. The monitor allows tracking of mechanical wear and of any loss of the oil s lubricating properties.

Hand-held and user friendly Numerical readout to facilitate trending Can store calibration (good oil) in its memory Shows changes in oil condition affected by such things as: Water content Fuel contamination Metallic content Oxidation

Order Code

C1464695

656